Some ramblings
The above graphs are simulations for the Whole Cold-side of the system(Chiller Cold-side + cpu & mb + pump+Tubing/instrumentation)
Ri is interpreted as the Resistance between the system and Ambient* Air
Pissing about with the paramters can give results showing similar trends to the observrd, e.g
To explain the increase in Watts extracted with Flow rate need a rate dependant source and/or a rate dependant resistances(Rc and Ri).
Flow dependant source: - Pump Heat production increases with Flow rate** (Eheim1048,Limited to mfrs specs of 10w?) (and Rc decreases)
Flow dependant Resistance:- (1) cpu & mb, Resistance Rc decreases with increasing Flow-rate.
(2) cpu & mb, Resistance Ri decreases with increaing Flow-rate? (connected in series with Primary cpu and mb sources)
(2) Tubing/instrumentation ,Resistance Ri decreases with increasing Flow-rate
*ambient in the Primary Kyotherm calculations is interpreted as the Hot-side Water
** Since87's numbers here
http://forums.procooling.com/vbb/sho...5&pagenumber=7