[Blackeagle]

Funny, I agree both with JD & Player0 on this block.

I think it's without doubt a clone of WW even prior to reading that past thread. But I also agree with Player0, it's also a clone of the Cascade.

ALL this RBX is, if you look again, is a overlaying of the Cascade jet holes over/with the channels of the WW.

Then add a adjustable inlet, only this one is adjustable by buying more plates from DD for $$$ more.

AS the (designer? NOT) cloner took the best from the WW and Cascade with a changable inlet added in, I'd be damned surprised if it didn't do well.

Not impressed. I've a original Cascade that I'll use.

EDIT:

Rotor posted that pic while I was typing and retyping (editing) my above post. Pretty clear the "creator" of this RBX block found this forum to be a gold mine of info. Perhaps he used Balinju's depicted consept for his blueprint instead of overlaying a Cascade pattern of hole through a WW base.

The more about this I've read the less impressed I get. $$$$ for DD from those to whom only low cost matters and F*** Cathar's and others hard work. I hope, if this thing does turn out to perform at high levels that CAthar's recouped all cost of development and testing his various designs.

And DD can be VERY sure, I'll not be buying this, or anything else they sell.