Well I posed this question on another thread, what do you guys think? BTW Player0 could you post some decent pics of the inside of your block, similar to the ones on modfather site? I'd like to compare the toolmarks......
One thing I'm curious about....I'm wondering if that block isn't molded instead of completely machined. This would greatly reduce the cost of producing them after the intial outlay of cash. I know there are what seems to be toolmarks on the block from the review pics, but these could easily be carried over from marks on the mold. You guys that would know, please take a close look at the pics with that in mind. Specially the closeup of the VOID sticker. Ya see how the profile is beveled a bit, and bigger at the top 1/3? I can't even remotely imagine a reason why that would be done. It would also explain why they bead blasted the whole thing and then possibly tapped the holes and finished the bottom. Like I said, I'm jjust curious about this and wonder what you guys think. Also I remember reading about copper having different thermal properties depending on if it was cold rolled or molded. I can't remember how they compared with each other though.
peace.
unloaded
|