Quote:
Originally posted by Blackeagle
What I thinking at this point Tex707 is to cut the Lexan 1/2" top (one side) at an angle. Combined with a thin based block with pins raised up out of it I think this can work.
Pins would be approx. .2" (5mm) and the top would be .5" Lexan,
with a thinner 1/8-3/16" base.
I'll rout a square area for the pins into the Lexan top. Although I may also use a copper 1/2"=>3/8" bell reducer as the inlet to get a bit more water velocity to impact the base with, & a bit of 1/2" copper tube for the open low restriction outlet.
A question I still have.
Is the .2" pin hieght a good length? I'm open to advice on this as I picked this .2 height as it would be handy to work with along with a 1/2" top of Lexan.
|
Is this at least close to your idea..??..I'll wotk on the copper base and a pocket in the top later...