Quote:
Originally posted by satanicoo
Of course you could remove the midle place, becoming much less restricted, but loosing ~2 degrees (as cathar stated).
|
Yes, removing the middle plate will make the block less restrictive than a Maze 3.
I had kinda figured that the ~15% water-flow-rate loss wasn't really that extreme to cause people angst if it gave them better performance.
What do I know though? Higher flow rates equals better performance, so hacking apart a block to raise the flow rates has always got to be better, right?
I wouldn't drill into the White Water unless you want to run the very high risk of putting a hole in it.
Widening the nozzle would be one's best best to improve flow rates without sacrificing too much on performance.