Quote:
Originally posted by Blackeagle
I don't see why that would be impossible. But what if the hole being drilled from the water chamber were drilled on a drill press with a tiltable table. Or could be done by clamping the Lexan in a drill vise. Then you could drill the hole on a slant and avoid the 90 degree corner. Instead it would be say 65-70 degrees, saving a bit of flow for you while still allowing you to have the side mounted barbs you are making use of. Anything to avoid 90 degree bends! 
|
Use a drill press with a tilting vice and a ball nosed endmill and you golden.
