Pro/Forums - View Single Post

jaydee · 11-13-2003, 12:59 PM

This is what I have so far on the GPU bock. It is a very tight fit if I use those 4 holes. Even with the smaller area and less pins there is still plenty of surface area as the GPU is smaller than the NB. Only problem I see is the inlet and outlet. I plan on using a Copper top and soldering pipe that bends around the card and up in the direction of the NB block so I think I will be fine there.

The CPU and NB blocks will have clear tops. The CPU block is already done as per the other thread.

So what I have left to do is confirm the mounting holes for both the GPU and Asus NB block. I should be able to do that tomorrow on the laser. Just the same as I did with the standard NB block.

I setup the test bench last night but it failed the leak test.

I need a couple more hose clams in one spot. that 3/4" tubing just dopesn't such up as much as the smaller sizes. Especially with a 500GPH pump. Once that it sealed up I will start testing the King Pin against the Maze 4 and the Lemon Block Cu. Should be doing that all next week.

EDIT: For got the pic.

11-13-2003, 12:59 PM	#120
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	This is what I have so far on the GPU bock. It is a very tight fit if I use those 4 holes. Even with the smaller area and less pins there is still plenty of surface area as the GPU is smaller than the NB. Only problem I see is the inlet and outlet. I plan on using a Copper top and soldering pipe that bends around the card and up in the direction of the NB block so I think I will be fine there. The CPU and NB blocks will have clear tops. The CPU block is already done as per the other thread. So what I have left to do is confirm the mounting holes for both the GPU and Asus NB block. I should be able to do that tomorrow on the laser. Just the same as I did with the standard NB block. I setup the test bench last night but it failed the leak test. I need a couple more hose clams in one spot. that 3/4" tubing just dopesn't such up as much as the smaller sizes. Especially with a 500GPH pump. Once that it sealed up I will start testing the King Pin against the Maze 4 and the Lemon Block Cu. Should be doing that all next week. EDIT: For got the pic. Last edited by jaydee116; 11-13-2003 at 01:07 PM.