View Single Post
Unread 11-15-2003, 06:49 PM   #19
jaydee
Put up or Shut Up
 
jaydee's Avatar
 
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
Default

Quote:
Originally posted by leejsmith
i feel like i am a little fish swimming with the big sharks but here goes.

i dont know if this is possible but you could improve on this by only using 2 hold down screws or even better one.
Like an old pulp press with one one big screw on top. this should allow even pressure to be applied in one motion instead of one at each corner.

just something that i thought after seeing the pictures at oc.com


[/IMG]
Damn, thats a lot like what I had in mind. Sit the scale on the base that is adjustable on 4 points for alingment, the die sim on the scale, and then lower the block from the top to get your pressure.
jaydee is offline   Reply With Quote