View Single Post
Unread 11-17-2003, 11:47 PM   #12
Gooserider
Cooling Savant
 
Gooserider's Avatar
 
Join Date: Jun 2003
Location: North Billerica, MA, USA
Posts: 451
Default

Quote:
Rayman2k2:
define small car radiator...
An engine radiator, not a heater core, from a small car (i.e. Ford Escort) as opposed to one from a big car (i.e. Ford Explorer) Of course if space isn't a major issue, there isn't any real reason not to go for a really big radiator like one from a large car or truck.
Quote:
Rayman2k2 very nice then. only one problem though, how hard is it to send pipes down two floors? do i just make a hole in the wall and shove it down? or do i have to search for holes in the floor board? my basement is not finished, btw.
Obviously if you can find appropriate holes that would be better, but it isn't likely. However, if your basement isn't finished, it's fairly trivial to drill, just use an appropriate size drill bit. I would reccomend drilling a smaller hole for each individual tube rather than a big hole for all of them together. The hole should probably be slightly bigger than the tube, and you should plan to put some sealant / padding around the tube where it goes through the floor to avoid problems with sharp edges and to keep your heat or AC where it belongs.

You MAY have a problem with the length of the bit, some floors can be thicker than many standard size bits are long. You can either buy extra long bits, or extensions for certain types of bits. Choosing a bit that can handle hitting a nail is also a good idea.

It is important to measure very carefully to make sure the holes are in the right place, and you should try to avoid hitting any of the joists or rafters holding up the floor. The other thing to watch out for is that the space you are drilling through is free from electrical wiring, gas or water pipes, heating ducts, and other such obstructions. Since most of these will be on the basement side, it is probably best to drill from the basement up, at least initially.

I would probably start by drilling a very small hole (1/8"?) from the basement up, and then stick a coat hanger through the hole to make sure I was in the right place, and was clear of any obstacles. Then I would get my bigger bits and drill down from above to make the finished hole (easier to work with gravity, and avoids getting a face full of sawdust).

Gooserider
__________________
Designing system, will have Tyan S2468UGN Dual Athlon MOBO, SCSI HDDS, other goodies. Will run LINUX only. Want to have silent running, minimal fans, and water cooled. Probably not OC'c
Gooserider is offline   Reply With Quote