Pro/Forums - View Single Post - A noob water block design. Input and ideas welcome!

jaydee · 11-18-2003, 08:59 PM

Here is and example. This is similar to what I am going to be building. I will use a ball nosed endmill to drill the holes, then a regular square end endmill to finish the holes to make the flat bottomed, then use a endmill to make the cuts. I plan on doing it all on my CNC mill. This can be done with a drill press though. The cuts can be mase with a dremel.

11-18-2003, 08:59 PM	#37
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Here is and example. This is similar to what I am going to be building. I will use a ball nosed endmill to drill the holes, then a regular square end endmill to finish the holes to make the flat bottomed, then use a endmill to make the cuts. I plan on doing it all on my CNC mill. This can be done with a drill press though. The cuts can be mase with a dremel.