View Single Post
Unread 11-23-2003, 07:58 PM   #7
Blackeagle
Thermophile
 
Join Date: Oct 2002
Location: U.S.A = Michigan
Posts: 1,243
Default

Where is the rad mounted? If at the case top, or with the barbs down at the bottom with the remainder of the rad above the barbs, you could have a air pocket trapped in the rad, which would put a real hit on the rads cooling if the air pocket is large. Have you checked for a air pocket trapped inside the rad?

Evercools look very nice but there are much higher pressure fans. Might want to put a 38mm fan (a Delta 130 cfm fan on a reobus can run just as quiet as the Evercool does at max cfm, but a LOT higher pressure.) in place of that Evercool which is only 25mm thick.

As someone else asked, how tight are the springs? Might tighten them and gain some improvement.
Blackeagle is offline   Reply With Quote