Pro/Forums - View Single Post - Water Block to Die Sim Alignment project.

jaydee · 11-24-2003, 01:52 PM

Good points UberBlue.

Ben you can just make the bottom adjustable with the 4 corner approch JoeC took and get it close. Then the ball joint should take care of the fine tuning by itself I would think. It should automatically move in order to flush mount the block and the die. Could be wrong..

11-24-2003, 01:52 PM	#21
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Good points UberBlue. Ben you can just make the bottom adjustable with the 4 corner approch JoeC took and get it close. Then the ball joint should take care of the fine tuning by itself I would think. It should automatically move in order to flush mount the block and the die. Could be wrong..