1) I think that my system resembles the jet impingement, in my design the water is also pressend on the bottom, but in my design the water can get away better, then in jet impingement blocks...so I think.
2) Is it true dat copper can deform when in use (because the center is hotter ?)
3)Could I do without an O-ring? I think I would just do some silicone between the top and bottom part and then bolt it tightly together...
4) What kind of fittings should I use? (considering the water is pushed on the block in the shape of the core-->need good pressure)
5)What kind of pump should I use?
Eheim 1048 (600l/hour), Eheim 150 (1200l/hour), Eheim 1046 (300l/hour),... so much to chose from
5)Rad:
would one like this be overkill? I think she's so hot
(remember I'm after great performance
)