View Single Post
Unread 11-30-2003, 07:45 PM   #90
Blackeagle
Thermophile
 
Join Date: Oct 2002
Location: U.S.A = Michigan
Posts: 1,243
Default

Man Jaydee, you turn out new variations of blocks fast. Used a ball tip end mill on the pin block, or at least that the way it looks.

Did you also use the ball tip mill on the block with the irreguler channels?

I hope you have time to run some of these blocks on your test bench soon.

Nice work!
Blackeagle is offline   Reply With Quote