Part 2
With the Radiator situation underway, I had to get started on where it would sit in the case. I was hoping for it to sit on the front right under the 5 1/4" drive bays. But making it fir there was going to be a bitch. So I decided, since there was already 92mm fan holes there, to put it on the left side.
---
You can see there where I've used the Jigsaw and Metal Cutters to cut away the metal. This is so much tougher than my Lian Li, the Lian Li was like a hot knife through butter, this is one stubborn POS. I've marked out in nikko where I am going to cut with the Jigsaw. I've marked out all three fan holes to be cut, but I'm only cutting two as I'll only need two for this shroud and radiator. The third one there is for when I get my next heatercore, that's if I do, this one might do the job well enough.
Just measuring things up to make sure they fit.
[===]
When I get a chance I'll draw up a diagram of the flow pattern of the setup.
That's enough for me today.
Banzai.