Pro/Forums - View Single Post

crxy_sasquatch · 12-05-2003, 03:15 AM

I just drew this one

The gap in between each square pin is 1/16" (I'm not sure if there is even such a small milling bit) And each square is .15" big. I chose .15 because it's each turn on the milling machine is 0.2 inches, so I can just turn it 3/4 each time.

The cut between the pins and the inside cut is 1/4"

12-05-2003, 03:15 AM	#3
crxy_sasquatch Cooling Neophyte Join Date: Jul 2003 Location: B.C Canada Posts: 13	I just drew this one The gap in between each square pin is 1/16" (I'm not sure if there is even such a small milling bit) And each square is .15" big. I chose .15 because it's each turn on the milling machine is 0.2 inches, so I can just turn it 3/4 each time. The cut between the pins and the inside cut is 1/4"