Need a little assistance:
Seems like I saw where somebody had a pen that could draw lines on a circuit board that was conductive.
It appears that I have damaged some surface areas of a 1.33 AHYJA "Y" series T-bird. There are three small chips in a row. They have a surface that is covered with some type of material that has become damaged. Got this attaching and reattaching a water block.
My thinking was to try this conductive pen to resurface the two tiny chips.
Anybody got any advice?
Hate to buy a new one if this solution would resurrect this chip. It was a good chip. Alas, I knew it well.
