[Titan]

so i could say that a strong pump could minimise this head loss.
As it could fill up this reservoir fast enough and still maintain a flow rate close to the inlet flow when it passes through the array to the base plate. (As in the picture attached)
If so, does this mean only an area slightly bigger than ID of the hose barb could be made or could it be bigger. I want to make a small reservoir about half the size of the P4 IHS, with the ID of the hose barb ~11mm , im concentrating on cooling this portion of the IHS. I know there are some blocks out there with this reservoir, i just want to know whether is it almost as "efficient" as those with "direct" inlet to the baseplate.