View Single Post
Unread 12-14-2003, 06:34 PM   #1
zachsss62688
Cooling Neophyte
 
Join Date: Dec 2003
Location: USA
Posts: 2
Default Pressure requirements?

Pressure requirements seem to be the most confusing thing in the new setup I'm building. First, since I'm going TEC, the components are the polar opposite of restrictive- Swiftech MCW50 on GPU and MCW462 on CPU, most likely MCW20 on NB, and 2-342 heatercores (one for each loop, since the gpu/nb and cpu are going to be two separate loops). If this was for a setup going directly in the PC case, I have no doubts that just about anything would do it... I could just throw in a Hydor and be done with it. However, the fans/radiators are going to be mounted in a box that is about 7-8' away from my pc, with tubes routed on the floor behind my bed. The box setup has a minimum of elbows, and the ones that are there are either just bent tubing (1/2" Clearflex 60- no kinks ) or 1/2" PVC, so they don't terribly restrict flow. Would a single Iwaki MD-15RLT, with a Y splitter on the input and output, be enough to handle both loops?
zachsss62688 is offline   Reply With Quote