You shoulda kept them. Dreads = teh shizz. I wish I had dreads when I'm listening to reggae or 311 in my car
Back on topic... The design of the tops. I have a few ideas regarding how to spread the water flow over the entire block.
For the GPU block, I will first cross drill two holes almost all the way through the block. The fins are 11mm tall (according to the review), so I will have to gouge out 11mm of plastic out of the middle to accomidate them. This will create the two channels for water to be spread to the entire cooling surface.
The NB block will have to be a far different design. I am having trouble figuring out how to do all of it exactly. I will still have to remove 11 mm, but I'm not sure of barb placement or how I am going to make the channels to spread out flow.
Maybe I should just wait until I have the HS and the other supplies
