i have seen a couple of things made by slm, (althogh i thought it was called sls), andthey were perfect. they were small nosy pieces for baby incubators.
the problem being, that it took 6 hours to make it, and it was only about 2cm by 1cm big. It was dont in the US, the exchange rate worked out for it to be $NZ120,000 to make the tool. kinda out of budget for this project me thinks!!
but the cascade wont need large resolution like this tool needed, because there are no sloping surfaces, everything is vertical, it may be able to get done a lot faster
|