well yes i do have a second tube running which is attached with a y-type fitting to evenly split the coolant. so i wont over heat the last in line chips if i used one continuous piece of tubbing from front to back.with the way my chiller is running i will be able to supply the memory and gpu anywhere from -27c( gpu -50c pelt cooled ) to room temperture coolant to cool the card by slowing down my coolant flow.
i like the link you gave me, i had already been following the guys work.but i have one problem .since i have a mill i could easyly do what he did but.........i found the memory chips on the card are not perfectly in alignment.so using a one piece type cooler one or some of the memory chips will not touch flat.and it is no way to compensate for that.it all depends on the board manufactuing process and how well the board is made.
so the copper tubbing i made can be hand bent with some time.to giveme perfect contact of all the momory chips.and on the card i am also cooling the memory voltage regulator which needs to be cooled also(it has a big impact on memory speed).
__________________
xp2800barton@2712 226x12 dual bank 2x256 twinmos pc3200 8RDA epox full mods.vdd,vdimm,vcore.
custom r502 cooled unit.CPU running @-18C GPU -21C Chipset -20c
only one like it.in one case.
custom r502 cooling unit
3D2001SE 21315
3DMARK03 6659