View Single Post
Unread 10-23-2007, 07:06 PM   #25
ulairi
Cooling Neophyte
 
Join Date: Aug 2007
Location: Stateside
Posts: 17
Default Re: New setup (sanity check)

Dremel XPR 400 + Tungsten Carbide Cutter vs. The back of the case:
Dremel: 0, Case: 1

Time to go get a regular drill and a step drill bit. (Was hoping to put off futher tool shopping until the Christmas bonus time...)

On a separate topic - any suggestions on the fill & bleed procedures? Tricks worth knowing? I figure I'll have to do some tilting and flipping of the whole rig (while the pump is off, of course) to dislodge the large pockets. The small stuff - therein lie the trickier stuff, so any help would be appreciated.
ulairi is offline   Reply With Quote