First Question:
where can one find refrigerant.. i mean to make a Direct phase cooling system youre going to design the components part by part and then interconnecting them. This would mean that U would have too add refrigerant to the system .. where can one find that ?
Second Question:
Should u not have a separator (vapor / liquid) before the compressor ?
Correct me if i am wrong, If u don't have a seperator the compressor could work abnormal (bubbles) and lead to explosion danger (potential) ?
And if u don't have a seperator u should have enough evaporation area (right ??), I don't think cooling a cpu is sufficient ... or am i mistaking here.
Evaporator design do u have a guide--> block on cpu)
Third Question:
For the reducing pressure U used cappilary tubes or ..?? did u contruct it u'r self ? GUIDE ?
or just using one off a Fridge ...?
how about a guide...