some results.

[kozoman]

well so far im down. 1 amd 1.3g & 1 duron 800 chipset
The duron,chiped the corner of the heatplate,messing with the stock hsf.
The t-bird, died cracked in half with a lil help, from me to see what the line was on it.
recoup my lossses and the store give's me a brand spanky new. 800 duron.
No suck luck with the t-bird

@ present the lil duron runs @ 1010mhz.
110 w peltier
oc watercool.com copper bloc.
getto rig heater cores from various cars.
pump and res. from home depot.
all on top of ,
abit kt7a
riad 0
micron. pc133
sblive,dvd,3com nic.
millenium. edition. blah.
so far. ive been able to run the proc ,
down to 22.f@800mhz/full load 40f.this is also. with the volts at 1.40 on the utility with the board.
seems to want to lock up after i leave it for a few hours.

running at the present 1010mhz, it idles@32/33f.
and full load some counter stirke of. quake 3. it goes in to the high 50's f.

all this with some warm ass . water.hovers around 89 &90 f. ambient in room. being low 80s f.

using home made lexan retainer on the blocs
; to the board,regular white thermal compound. and vaseline, everywhere under the proc till it kinda oozed out.
all this meticulousy. wraped and packed in a 1/4 in. rubber pad stuff " from the carpet guy" and ziptied around the whole enchalata.

till i can get a p/s for the 156w pelts. or a fridge to cool off the water a bit more. im stuck here. hope this or anything has helped anyone...... peace out.