Cheap/Easy/Professional Radiator Shroud

DarkEdge · 07-21-2002, 08:10 AM

Was looking for a professional/cheap shroud to make. I've used the tape route and tried few other ideas until I decided to try something new. I havn't seen it done before, so I thought I would share.

Take an electrical junction box, cut the bottom half off. Cut your hole out too. Then just paint it up so its not that ugly grey.

Easy/Cheap/Professional looking.

Khledar · 07-22-2002, 04:27 PM

How small is your rad and... How big is the junction box?

DarkEdge · 07-22-2002, 07:24 PM

Its a 6x6 heatercore. The fin surface area that is. I don't remember what model it is. The junction box is also a 6x6 box. Matches perfectly.

07-21-2002, 08:10 AM	#1
DarkEdge Cooling Savant Join Date: Mar 2001 Location: Sugar Land, Tx Posts: 176	Cheap/Easy/Professional Radiator Shroud Was looking for a professional/cheap shroud to make. I've used the tape route and tried few other ideas until I decided to try something new. I havn't seen it done before, so I thought I would share. Take an electrical junction box, cut the bottom half off. Cut your hole out too. Then just paint it up so its not that ugly grey. Easy/Cheap/Professional looking.

07-22-2002, 04:27 PM	#2
Khledar Cooling Savant Join Date: Mar 2002 Location: North Vancouver BC Posts: 234	How small is your rad and... How big is the junction box? __________________ "mooooo" said the cow. ERTW - UBC P4 2.4B @3.01Ghz 167FSB :: Abit IC7 :: 2x256MB HyperX PC3700 :: ASUS 9600XT :: WD Raptor 2x36GB RAID0

07-22-2002, 07:24 PM	#3
DarkEdge Cooling Savant Join Date: Mar 2001 Location: Sugar Land, Tx Posts: 176	Its a 6x6 heatercore. The fin surface area that is. I don't remember what model it is. The junction box is also a 6x6 box. Matches perfectly.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)