Question about innovatek compression fittings

scopEDog · 09-25-2002, 09:19 AM

Hey guys.. quick question about the compression fittings innovatek uses. They say you need 8mmID/10mmOD tubes, so i went to mcmasters looking for an r-3603 equivalent. The closest I've found is 5/16"ID-7/16"OD (7.9mm-11.1mm). Would this tubing be to big to fit? Thanks fellas..

bigben2k · 09-25-2002, 09:45 AM

Those measurements are within 1% of the specifications, so my vote is "yes, it'll fit!"

scopEDog · 09-25-2002, 10:10 AM

Thank you sir

I just needed someone else to say it was ok

09-25-2002, 09:19 AM	#1
scopEDog Cooling Neophyte Join Date: Apr 2002 Posts: 49	Question about innovatek compression fittings Hey guys.. quick question about the compression fittings innovatek uses. They say you need 8mmID/10mmOD tubes, so i went to mcmasters looking for an r-3603 equivalent. The closest I've found is 5/16"ID-7/16"OD (7.9mm-11.1mm). Would this tubing be to big to fit? Thanks fellas..

09-25-2002, 09:45 AM	#2
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	Those measurements are within 1% of the specifications, so my vote is "yes, it'll fit!" __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101

09-25-2002, 10:10 AM	#3
scopEDog Cooling Neophyte Join Date: Apr 2002 Posts: 49	Thank you sir I just needed someone else to say it was ok

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)