Rocking Along...

Joe · 08-20-2003, 09:48 AM

This last week or so I have been working my tail off on some side project sites I am launching the end of August. I am also still working on my quiet air cooling project which has so far been a failure with no ballance of quiet/stability found. So I am looking at revamping the project from the bottom up and replacing the limited Chenbro Jr Case with a modified Chenbro Genie case via www.CoolCases.com. I am also purchasing a CF633 in the coming days, and a dozen of the DOW sensors to wire up in the case to control the temps in all the areas of the case with as little speed as possible on the fans.

The Project(s) are moving right along... and very soon there will be some new/cool stuff coming up with the launch of the new side project sites (which I think will be of interest to many of you), and the completion of this project which is quickly increasing in scale and cost

pHaestus · 08-20-2003, 10:32 AM

Joe:

Remind me when you get the CF633 and I can send you some sensors. I dont think they have them available for purchase with the units yet at CF. Also remind me in chat and I'll give you the contact information for the person I know there. I think he can get you a bit of a discount.

As far as the success or failure of quiet cooling goes, this certainly smells like a job for dihydrogen oxide! Get a couple of the swiftech blocks that use socket lugs, a BI Xtreme and a pump and go to town. You should be able to fit it all in the Junior no problem.

Joe · 08-20-2003, 10:34 AM

the scale of the project has the possability to jump to a mini DH3 level rather fast here.

I just emailed CF about getting 2 CF633's (just via sales@cf... but I will ask you bout your contacts cause discounts rock)

, and have confirmed the Modified Genie case. I was just looking through getting abotu a dozen D1822 DOW sensors, but if you got some spares that would rock.

If I was to do anything special like water, I would first look into a custom heatpipe setup. Which may not be THAT far off.

Blackeagle · 08-20-2003, 10:39 AM

It all looks good!

Will look forward to it all.

08-20-2003, 09:48 AM	#1
Joe The Pro/Life Support System Join Date: Dec 1999 Location: Denver, CO Posts: 4,041	Rocking Along... This last week or so I have been working my tail off on some side project sites I am launching the end of August. I am also still working on my quiet air cooling project which has so far been a failure with no ballance of quiet/stability found. So I am looking at revamping the project from the bottom up and replacing the limited Chenbro Jr Case with a modified Chenbro Genie case via www.CoolCases.com. I am also purchasing a CF633 in the coming days, and a dozen of the DOW sensors to wire up in the case to control the temps in all the areas of the case with as little speed as possible on the fans. The Project(s) are moving right along... and very soon there will be some new/cool stuff coming up with the launch of the new side project sites (which I think will be of interest to many of you), and the completion of this project which is quickly increasing in scale and cost __________________ Joe - I only take this hat off for one thing... ProCooling archive curator and dusty skeleton.

08-20-2003, 10:34 AM	#3
Joe The Pro/Life Support System Join Date: Dec 1999 Location: Denver, CO Posts: 4,041	the scale of the project has the possability to jump to a mini DH3 level rather fast here. I just emailed CF about getting 2 CF633's (just via sales@cf... but I will ask you bout your contacts cause discounts rock) , and have confirmed the Modified Genie case. I was just looking through getting abotu a dozen D1822 DOW sensors, but if you got some spares that would rock. If I was to do anything special like water, I would first look into a custom heatpipe setup. Which may not be THAT far off. __________________ Joe - I only take this hat off for one thing... ProCooling archive curator and dusty skeleton.

08-20-2003, 10:32 AM	#2
pHaestus Big Player Making Big Money Join Date: Aug 2001 Location: irc.lostgeek.com #procooling.com Posts: 4,782	Joe: Remind me when you get the CF633 and I can send you some sensors. I dont think they have them available for purchase with the units yet at CF. Also remind me in chat and I'll give you the contact information for the person I know there. I think he can get you a bit of a discount. As far as the success or failure of quiet cooling goes, this certainly smells like a job for dihydrogen oxide! Get a couple of the swiftech blocks that use socket lugs, a BI Xtreme and a pump and go to town. You should be able to fit it all in the Junior no problem.

08-20-2003, 10:39 AM	#4
Blackeagle Thermophile Join Date: Oct 2002 Location: U.S.A = Michigan Posts: 1,243	It all looks good! Will look forward to it all.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)