WB design like the Cascade or Jet block...

Phant0m51 · 08-11-2003, 10:56 PM

Ok, I've been thinking about this alot lately, and want to know what you guys think. This is just a rough sketch in MS Paint, so if you don't understand any of it, just let me know. I think it's a good design. Maybe I could add more 'cups' below the cones?

Any suggestions are welcome! (Even the 'That will never work' one's are welcome)

Tear it apart and tell me if it'd be worth the effort and $. If nobody has any difinitive idea on if it'll work, then i'll probably make it for the benefit of the group.

winewood · 08-12-2003, 02:23 AM

I think its a fine idea. The only question is this.. once you drill into copper or aluminum, the walls of the connected cups will tear out.. so you have a 4 leaf clover looking thing. The internal pin that separates the water into the outside cups will be/could be a jagged sharp spear or a point. Basically its almost just a larger cup with a pin in the middle.. kinda like a rotor block, that has the drilled holes separated out across the base.

08-11-2003, 10:56 PM	#1
Phant0m51 Cooling Savant Join Date: May 2003 Location: Utah Posts: 160	WB design like the Cascade or Jet block... Ok, I've been thinking about this alot lately, and want to know what you guys think. This is just a rough sketch in MS Paint, so if you don't understand any of it, just let me know. I think it's a good design. Maybe I could add more 'cups' below the cones? Any suggestions are welcome! (Even the 'That will never work' one's are welcome) Tear it apart and tell me if it'd be worth the effort and $. If nobody has any difinitive idea on if it'll work, then i'll probably make it for the benefit of the group.

08-12-2003, 02:23 AM	#2
winewood Cooling Savant Join Date: Nov 2002 Location: in my chair Posts: 574	I think its a fine idea. The only question is this.. once you drill into copper or aluminum, the walls of the connected cups will tear out.. so you have a 4 leaf clover looking thing. The internal pin that separates the water into the outside cups will be/could be a jagged sharp spear or a point. Basically its almost just a larger cup with a pin in the middle.. kinda like a rotor block, that has the drilled holes separated out across the base. __________________ -winewood-

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)