water cooled controller

BaconGrease · 02-11-2003, 06:36 PM

you know what I need...
a water cooled xbox controller... god damn my hands sweat when I play.
Looked into that aircooled controller but reports are it gives out after a short while.
Someone here needs to get cracking on that... maybe me.

mfpmax · 02-12-2003, 07:53 AM

Well get too it...its been done before.

bigben2k · 02-12-2003, 09:32 AM

Strap a Pelt to it...

BaconGrease · 02-13-2003, 07:05 PM

thinking of milling a couple of copper gloves, with 1/2 inch entry barbs at the wrist 1/2 inch exit at each thumb. Micro channels and turbulators across the palms. Would then have to lap the contollers to a mirror finish and pressure epoxy it to the gloves.
Couple it with a bong cooler and an eheim pump.
but of course the next question is always...
pump->glove->bong
or
pump->bong->glove

02-11-2003, 06:36 PM	#1
BaconGrease Cooling Neophyte Join Date: Dec 2000 Location: Richmond Posts: 85	water cooled controller you know what I need... a water cooled xbox controller... god damn my hands sweat when I play. Looked into that aircooled controller but reports are it gives out after a short while. Someone here needs to get cracking on that... maybe me. __________________ Damn that is hot

02-12-2003, 07:53 AM	#2
mfpmax Cooling Savant Join Date: Oct 2000 Location: Rockledge,FL,US Posts: 731	Well get too it...its been done before. __________________ My old and retired watercooling setup. Watercooled K6-2 450 at 600 Also Retired - Watercooling an XP1800@1782MHz

02-12-2003, 09:32 AM	#3
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	Strap a Pelt to it... __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101

02-13-2003, 07:05 PM	#4
BaconGrease Cooling Neophyte Join Date: Dec 2000 Location: Richmond Posts: 85	thinking of milling a couple of copper gloves, with 1/2 inch entry barbs at the wrist 1/2 inch exit at each thumb. Micro channels and turbulators across the palms. Would then have to lap the contollers to a mirror finish and pressure epoxy it to the gloves. Couple it with a bong cooler and an eheim pump. but of course the next question is always... pump->glove->bong or pump->bong->glove __________________ Damn that is hot

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)