how bad is this going to hurt my flow?

kronchev · 06-25-2004, 03:08 PM

OK. ok ok. I know Ive always loved the t-lines. but now...I have seen the aqua computers silver metal res

http://snt-systems.com/catalog/produ...products_id=97

and, well, i love it (in silver obviously). Of course, its ze german and they use the metric system, which does not match our american system too well. if I use the 12mm barbs (also sold at good ol' SNT), hwo bad is it going to hurt my flow in a 1/2" ID system? 12mm comes out to 0.47 inches which is a pretty big difference from 0.50, but i dont know how much it will REALLY matter.

any help is greatly appreciated. I dont have a girlfriend so I gotta waste my money SOMEWHERE

redleader · 06-25-2004, 08:39 PM

You could just drill them out if they're really .47 inch.

Regardless I wouldn't use an Aluminum res.

Also, nice pic. I'm going to see bad religion play next week in Phx. Can't wait, even if they're playing OUTSIDE in Arizona at 3PM :smileburstingintoflames:

AngryAlpaca · 06-25-2004, 11:21 PM

12mm=1/2" with the tolerances that we have. With plastic tees, a half inch one has 10mm ID and 15mm OD. :S

06-25-2004, 03:08 PM	#1
kronchev Cooling Savant Join Date: Mar 2004 Location: Lawrenceville, NJ Posts: 254	how bad is this going to hurt my flow? OK. ok ok. I know Ive always loved the t-lines. but now...I have seen the aqua computers silver metal res http://snt-systems.com/catalog/produ...products_id=97 and, well, i love it (in silver obviously). Of course, its ze german and they use the metric system, which does not match our american system too well. if I use the 12mm barbs (also sold at good ol' SNT), hwo bad is it going to hurt my flow in a 1/2" ID system? 12mm comes out to 0.47 inches which is a pretty big difference from 0.50, but i dont know how much it will REALLY matter. any help is greatly appreciated. I dont have a girlfriend so I gotta waste my money SOMEWHERE __________________ Ghetto riggin'!

06-25-2004, 08:39 PM	#2
redleader Thermophile Join Date: Jun 2001 Location: The deserts of Tucson, Az Posts: 1,264	You could just drill them out if they're really .47 inch. Regardless I wouldn't use an Aluminum res. Also, nice pic. I'm going to see bad religion play next week in Phx. Can't wait, even if they're playing OUTSIDE in Arizona at 3PM :smileburstingintoflames:

06-25-2004, 11:21 PM	#3
AngryAlpaca Cooling Savant Join Date: Jan 2004 Location: Alberta Posts: 631	12mm=1/2" with the tolerances that we have. With plastic tees, a half inch one has 10mm ID and 15mm OD. :S

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)