|
|
FS/FT Forum Are you looking to make some money? Get rid of some gear? This is the place to sell and buy it all! |
Thread Tools |
08-28-2004, 04:40 PM | #1 |
Big PlayerMaking Big Money
Join Date: Aug 2001
Location: irc.lostgeek.com #procooling.com
Posts: 4,782
|
Need Epox 8K3A or 8K3A+
My test system has gone to a watery grave. Would like to get a replacement mobo of same type to finish up a couple of things. Must be willing to ship to Canada
|
08-28-2004, 05:14 PM | #2 |
Responsible for 2%
of all the posts here. Join Date: May 2002
Location: Texas, U.S.A.
Posts: 8,302
|
How about a procedure to prevent this from happening again? i.e. a quick pressure test on the block, before mounting it?
(i.e. cap the block outlet, link the inlet to a pump and fill it all up with water: the pump would apply max head at no flow. A quick-and-dirty test... ) |
08-30-2004, 04:28 PM | #3 |
Cooling Neophyte
Join Date: Sep 2002
Location: MN
Posts: 23
|
I have one PH.. currently typing on it.. new box is just about done.. and willing to ship to CA.. not a problem.. hell I could drive it into Canada.. Gimme the address and will try and get it shipped out ASAP. Sad to hear about the watery grave.
Sure is incentive to get that new box running.. and get the test bench back up for ya pH. Sent ya an email |
08-30-2004, 04:36 PM | #4 |
Big PlayerMaking Big Money
Join Date: Aug 2001
Location: irc.lostgeek.com #procooling.com
Posts: 4,782
|
Oh man this is good news.
I dried system off and it SEEMED to work yesterday for a while. Then I went down to finish something last night and it was 100% dead again. I think it's on its last legs. A replacement would take a lot of stress out of my near future (I think alphacool wbs are in the mail for testing and I have some complete kits to run). |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|