|
|
Heatsink/ Heat Pipe / ThermoSiphon Cooling The cat will only make the mistake of putting its paw by your HSF once. :) Also the place to discuss the new high end heat pipe goodness. |
Thread Tools |
05-06-2005, 03:13 PM | #1 |
Cooling Savant
Join Date: Mar 2001
Posts: 155
|
very strange and even unknown effect happened
I give you fair readers a dilemma, what happened?
Look at poster mjs1231 and analyize his results, speculate, hypothesize... http://www.houseofhelp.com/v3/showth...250#post157250 http://www.xtremesystems.org/forums/...8&page=2&pp=25 Thank you for your support Please look towards the end of the posts in the current links Last edited by Bignuts; 05-06-2005 at 03:19 PM. |
05-06-2005, 03:52 PM | #2 |
Put up or Shut Up
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
|
Interesting that he can see the bottom of the heatsink and liquid come out of it when it is sitting on a burner.
|
05-06-2005, 05:23 PM | #3 |
Cooling Savant
Join Date: Mar 2001
Posts: 155
|
For clarification, the zalman 7000cu was upsidedown, on the burner, with cpu contact area facing up.
|
05-06-2005, 05:51 PM | #4 |
Put up or Shut Up
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
|
Pictures? Video? Proof?
|
05-08-2005, 02:25 PM | #5 |
Responsible for 2%
of all the posts here. Join Date: May 2002
Location: Texas, U.S.A.
Posts: 8,302
|
We all know that the contact surface is not perfectly flat, microscopically.
I can imagine some residue left from whatever process was used to manufacture heatsink/waterblock interfering with performance. Bill recomends cleaning between test runs using xylene. Otherwise, this fellow appears to have used a good thermal paste, and we (here) all know how much of an impact the TIM joint has. Possible. |
05-08-2005, 04:39 PM | #6 | |
Put up or Shut Up
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
|
Quote:
|
|
07-20-2005, 04:43 PM | #7 |
Cooling Savant
Join Date: Feb 2004
Location: W. Sussex, UK
Posts: 329
|
Most metals are slightly porus.
If its a copper h/s, melting solder into the base would fix it, and the exess would come off easly when lapped. I used solder like this to seal some porus braizing on a leaking barb on one of my blocks . Would have been better if I could braize properly though... In many industry using sintered metal products, they are "infiltrated" after with a copper alloy to seal it. Requires furnace with inert gas atmosphere to use anything other than soft solder though.... Dont know what filling the porus holes would do to performance though. I think it would be a small improvement, but noticable? probably not.
__________________
Waterblocks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
|
|