View Single Post
Unread 02-22-2006, 05:24 PM   #4
blue68f100's Avatar
Join Date: Jul 2005
Location: Plano, TX
Posts: 3,135
Default Re: acrylic joint fitup?

Hole saw are nominal, and will have a runout approx .0625 or greater, depending on how tight the mount is. They do not give a clean cuts, like other do. The most precision way would be with an endmill. I would proably use a fly-cuter. Some fly-cutters hold endmill cutters, instead of the standard insert. These will give you more control. Stay-away from carbides cutters, they require greater interface/force to cut. This is going to be a difficult cut, take your time. As for a cutting fluid, you will have to look and see what's on the market now.
1 Snap 4500 - 1.0T (4 x 250gig WD2500SB RE), Raid5,
1 Snap 4500 - 1.6T (4 x 400gig Seagates), Raid5,
1 Snap 4200 - 4.0T (4 x 2gig Seagates), Raid5, Using SATA converts from Andy

Link to SnapOS FAQ's
blue68f100 is offline   Reply With Quote