Radiator Shroud Size???
 

I have a Innovatek Dual 120MM Fan Radi that comes with an aluminum fan bracket already mounted. The only thing is that it's less than 1/2" off the radiator and I'm not sure if it's high enough to kill that dead spot on my fans.

How high should the fans be mounted away from the radiator to maximize it's efficiency? Also is there any special way or directions that it should be mounted or just the typical horizontal way?

No one really posts anything about this so I just thought I'd ask.

Re: Radiator Shroud Size???
 

i've read on this site that the 1/4" found on the BPIs is enough
so 1/2" should be better
however
the PA160 has 2-3"
of course that is also converting a 120mm fan to a 160mm rad...

anyway, you should be ok

if you are going to make your own, anything over 2-3" is overkill

jman

Re: Radiator Shroud Size???
 

Sorry but what is "BPIs"? I'm glad to hear that 1/2" should be good enough. Actually it's probably slightly higher than that as the fan blades are mounter on plastic that's at least 2mm thick.
I don't think I'll make my own as the Innovatek one I have now has the shroud permanently mounted on from the factory. I would have to do a lot of metal bending in order to get it off.
Thanks for the suggestion.