DD Hiflow to NPT adapters for Laing D5 brass housing?
 

Looking for some adapters I think I may be onto something here. I am close to the ultimate waterchill setup. I may have to do a revision 2 sometime when I have cash to blow. Please lets not discuss lesser options because you think this is impossible. I have no option but the best at this point. I'm on a mission. No thread crapping please.......

P.S. the laing d5 brass housing is .5 npt thread and the DD Hiflows are G1/4" BSPP.

Re: DD Hiflow to NPT adapters for Laing D5 brass housing?
 

Try these guys.... http://www.bsr-aerotek.com/store/index.php?cPath=2_199

At a guess, you'll need female > female inline adapters from this page: http://www.bsr-aerotek.com/store/ind...Path=2_199_200

And then the NPT > BSP adapter from this page: http://www.bsr-aerotek.com/store/ind...Path=2_199_221 (Assuming I have the genders correct)

If you have older DD Based stuff with the old 9/16UNF threaded fitting (HiFlow days before Perfect Seal - current HiFlow blocks are now G1/4"), the adapter to convert that over to 1/4" BSP is on this page: http://www.bsr-aerotek.com/store/ind...Path=2_199_214

HiPerformance hose and Python Clamps can be gotten here: http://www.bsr-aerotek.com/store/index.php?cPath=2_186

Re: DD Hiflow to NPT adapters for Laing D5 brass housing?
 

http://www.lainginc.com/D5_Vario.htm
I remember the pump having two types of brass pump housings.

The housing is 1/2" thread ( .5" looks strange) is female so he needs a 1/2 to 1/4 adapter.

http://www.bsr-aerotek.com/store/pro...oducts_id=2246
http://www.homedepot.com/prel80/HDUS...2498+100081876

no sure if the o-rings on the barbs will hold up to methanol, epoxy should do the job.
Cheaper going for nickel 1/2" barbs instead

Re: DD Hiflow to NPT adapters for Laing D5 brass housing?
 

Anyone know where I can pick up one of those brass housings?