Pro/Forums - View Single Post - Confused : Snap 1000

blue68f100 · 04-09-2006, 10:44 AM

You will need to reset the snap to factory. Then use assist.

You should only use a crossover cable if you are connecting to the snap directly from the PC.

If you are not using a router you will have to manually set the IP on your PC. Then use assist to set the Snap into the same subnet.

It only takes about 10 minutes to format a 80gig drive. Make sure the jumpers on the drive are set to Master.

After a reset and you still can not connect with Assist. It posiable that the OS did not copy corectly from your original drive.

04-09-2006, 10:44 AM	#13
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	Re: Confused : Snap 1000 - how far can i get You will need to reset the snap to factory. Then use assist. You should only use a crossover cable if you are connecting to the snap directly from the PC. If you are not using a router you will have to manually set the IP on your PC. Then use assist to set the Snap into the same subnet. It only takes about 10 minutes to format a 80gig drive. Make sure the jumpers on the drive are set to Master. After a reset and you still can not connect with Assist. It posiable that the OS did not copy corectly from your original drive. __________________ 1 Snap 4500 - 1.0T (4 x 250gig WD2500SB RE), Raid5, 1 Snap 4500 - 1.6T (4 x 400gig Seagates), Raid5, 1 Snap 4200 - 4.0T (4 x 2gig Seagates), Raid5, Using SATA converts from Andy Link to SnapOS FAQ's http://forums.procooling.com/vbb/showthread.php?t=13820 Last edited by blue68f100; 04-09-2006 at 10:51 AM.