Re: Problems with failure on a 2000 model in mirror mode
It apears the smart tech is reporting 10002 is failed, this is the master drive (10000, drive 0). It is also reporting a problem loading the os, too.
Make sure you set the jumpers correctly on your replacement drives. Some are M/S while others are CS, you can not mix. Master is usually the end of the cable.
The error you are getting may be due to the starrting point is not correct. This can happens if the snap has been upgraded or the existing HD are reporting a different capacity. HD with the same model number can have different capacity, due to a different firmware revision.
Has this unit been through update, starting with 1 or v2?
Run these cmd from debug, to get to debug:
ipaddress/config/debug and press enter. Ipaddress is the address of your Snap Server.
Enter in lo p -1 and press enter
Save the information as HTML only and email it to me.
and
"co de info"
|