Pro/Forums - View Single Post - Problems with failure on a 2000 model in mirror mode

blue68f100 · 03-25-2007, 11:52 AM

No, DON'T DO that or you will loose all. You can only read it with another snap.

Verify the jumpers are set correctly. If so try again. If no go, reset the snap to factory settings. Will not change the drive config, but will reset password and network settings. So you will need assist to set the IP address for your network.

03-25-2007, 11:52 AM	#9
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	Re: Problems with failure on a 2000 model in mirror mode No, DON'T DO that or you will loose all. You can only read it with another snap. Verify the jumpers are set correctly. If so try again. If no go, reset the snap to factory settings. Will not change the drive config, but will reset password and network settings. So you will need assist to set the IP address for your network. __________________ 1 Snap 4500 - 1.0T (4 x 250gig WD2500SB RE), Raid5, 1 Snap 4500 - 1.6T (4 x 400gig Seagates), Raid5, 1 Snap 4200 - 4.0T (4 x 2gig Seagates), Raid5, Using SATA converts from Andy Link to SnapOS FAQ's http://forums.procooling.com/vbb/showthread.php?t=13820