Re: Snap server 2200 will not turn on
Check the output on the ps. Should be 12vdc. Tese do fail from time to time. If I recall there is a fuse block on the mb. To the right of the power socket is a block 1/2" x 3/16" and around 1/2 tall. You should see 4 bare wires. This is the fuse block, check with meter, for a open. If failed just bridge the connection. Also if the battery is dead it will not start either.
Your best source for parts is eBay right now. Northwestern carries some older parts but has not had any of these 2200. They may in the future since Adaptec no longer sells or support them, unless it still in warranty.
Remember you must hold the power button for around 5-10 sec before it will start.
|