Pro/Forums - View Single Post - Re-init drive capacity in 2000v2

blue68f100 · 05-19-2007, 02:18 PM

Most case you can not reinit if in raid. So you must set to JBOD. Or wipe both drives clean and re-install into snap. Allow 10 min for the os to be installed before trying to connect. But in either case you can not have a raid. The drive info is stored in non-volatile ram.

CS/MS is all dependent on hardware versions. 4100 and v1 models (1000, 2000) use MS, where the later models use CS.

I checked your platform byte with the bios table and it matches for a 2000.

05-19-2007, 02:18 PM	#4
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	Re: Re-init drive capacity in 2000v2 Most case you can not reinit if in raid. So you must set to JBOD. Or wipe both drives clean and re-install into snap. Allow 10 min for the os to be installed before trying to connect. But in either case you can not have a raid. The drive info is stored in non-volatile ram. CS/MS is all dependent on hardware versions. 4100 and v1 models (1000, 2000) use MS, where the later models use CS. I checked your platform byte with the bios table and it matches for a 2000. __________________ 1 Snap 4500 - 1.0T (4 x 250gig WD2500SB RE), Raid5, 1 Snap 4500 - 1.6T (4 x 400gig Seagates), Raid5, 1 Snap 4200 - 4.0T (4 x 2gig Seagates), Raid5, Using SATA converts from Andy Link to SnapOS FAQ's http://forums.procooling.com/vbb/showthread.php?t=13820