Pro/Forums - View Single Post

blue68f100 · 05-26-2007, 11:01 AM

2200 are set to master, both drives. If you are in RAID0, loose 1 causes both to be lost.

Make sure the drives are in a RAID1 config.

If the 2200 does not boot swap the drives. and try again. Then use the disk utility to see which is the good drive. Then follow the upgrade in the FAQ's.

05-26-2007, 11:01 AM	#8
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	Re: 80GB upgrade to 250GB 2200 are set to master, both drives. If you are in RAID0, loose 1 causes both to be lost. Make sure the drives are in a RAID1 config. If the 2200 does not boot swap the drives. and try again. Then use the disk utility to see which is the good drive. Then follow the upgrade in the FAQ's. __________________ 1 Snap 4500 - 1.0T (4 x 250gig WD2500SB RE), Raid5, 1 Snap 4500 - 1.6T (4 x 400gig Seagates), Raid5, 1 Snap 4200 - 4.0T (4 x 2gig Seagates), Raid5, Using SATA converts from Andy Link to SnapOS FAQ's http://forums.procooling.com/vbb/showthread.php?t=13820