Pro/Forums - View Single Post

blue68f100 · 04-08-2008, 11:57 AM

I don't have a picture of the bottom of the circuit board. Basicly if you locate the power sw/button, it is secured with 4 solder post. The 2 front ones are not used, the 2 rear ones are the ones you need to short. These are connected (shorted) when you push the button in.

I checked, I don't have any photos of the 2200 MB. Moat all others mbut not that one. You can send me a photo, use atleast a 3mbp resolution so I have resolutions to zoom in.

04-08-2008, 11:57 AM	#12
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	Re: Snap 2200 Won't Power up I don't have a picture of the bottom of the circuit board. Basicly if you locate the power sw/button, it is secured with 4 solder post. The 2 front ones are not used, the 2 rear ones are the ones you need to short. These are connected (shorted) when you push the button in. I checked, I don't have any photos of the 2200 MB. Moat all others mbut not that one. You can send me a photo, use atleast a 3mbp resolution so I have resolutions to zoom in. __________________ 1 Snap 4500 - 1.0T (4 x 250gig WD2500SB RE), Raid5, 1 Snap 4500 - 1.6T (4 x 400gig Seagates), Raid5, 1 Snap 4200 - 4.0T (4 x 2gig Seagates), Raid5, Using SATA converts from Andy Link to SnapOS FAQ's http://forums.procooling.com/vbb/showthread.php?t=13820