Pro/Forums - View Single Post

Gulp35 · 11-08-2002, 05:15 PM

Here is my idea

The inlet is a 1/2"ID tube going over the center piece of copper. My Q is that I was thinking of drilling this out of a 2"x3"x1/2" piece of copper and drilling the channels a little less than 1/2" (7/16"?) how thin should the base be. Also how is my design? Any design advice would be appreciated but I would like any designs to be able to be made with a drill press. Thanks.

11-08-2002, 05:15 PM	#1
Gulp35 Cooling Savant Join Date: Sep 2002 Location: Atlanta, GA Posts: 135	Waterblock Noob needs help with design Here is my idea The inlet is a 1/2"ID tube going over the center piece of copper. My Q is that I was thinking of drilling this out of a 2"x3"x1/2" piece of copper and drilling the channels a little less than 1/2" (7/16"?) how thin should the base be. Also how is my design? Any design advice would be appreciated but I would like any designs to be able to be made with a drill press. Thanks. __________________ Epox 8RDA+ v1.1----------Tyan K8SDPro 1700+ JUIHB 0310XPMW (12.5x200Mhz@1.792v)--------2xOpteron246 (2Ghz 1MB L2) 2x256MB Kingston PC3000 (BH5?) 2-2-2-8 2.7v---2x512MB Corsair Reg.&ECC PC3200 ATi Radeon 9800Pro (stock, too hot)-----ATI RageXL WD800JB+WD2500JB-------WD1600JD Sony DVD/CDRW-------NEC 3520A Black Forton350W--------Antec TruePower2.0 550W EPS12v Last edited by Gulp35; 11-08-2002 at 05:25 PM.