MCP600 vs. DD12V-D4?

[J-Pepper]

I have a water cooled sonata... a thermochill 120.1 will fit on the 120mm exhaust

http://www.zen9424.zen.co.uk/webby/r_comp_photos.htm

this is what I have done... my complete specs include 2 rads, 4 fans, 3 blocks, 1 res and 1 pump.

[Tyop]

Originally Posted by msv

Tjenare, Tyop!
Where did You order the MCP600 from? I´ve tried to some distributor here in Sweden, but have failed so far (piling the failures, depressive hobby).
regards
Mikael S.

I've ordered from Sidewinder Computers in the US since none of the UK vendors had it or refused to answer emails. So far the service has been very good and prompt.

USPS on the other hand.. The shipment left the US on the 13th of march but has yet to arrive here in Sweden.

[Tyop]

Originally Posted by Tyop

USPS on the other hand.. The shipment left the US on the 13th of march but has yet to arrive here in Sweden.

Update! It turns out that Schenker BTL is USPS partner in change of deliveries here in Sweden and the package actually arrived on the 18th. Too bad they didn't bother informing me about it.

[fhorst]

Originally Posted by Maximilium

for the money you can spend on the D4 you should be able to do this, i am on my "test phase", i love this litle pumps, they are quiet.

I had a simular setup, but the pumps get loud if you place them in series. Does this also happen in your setup?

[Maximilium]

Originally Posted by fhorst

I had a simular setup, but the pumps get loud if you place them in series. Does this also happen in your setup?

no, i cant hear them over my fans.

[Maximilium]

[BillA]

Maximilium, good looking system
what are those compression clamps on the pumps ?
Thanks

[Maximilium]

Originally Posted by unregistered

Maximilium, good looking system
what are those compression clamps on the pumps ?
Thanks

First i have to thank Nexxo for posting the link for this cool looking clamps on his project thread, they are made by Py-Thon Design part number 6A-08 1/2 ID clamps, on 3/4OD-1/2ID tubing. I had a friend who made 2 aluminum bases for my pump. Here is where you can get them Link