![]() | ||
|
|
General Liquid/Water Cooling Discussion For discussion about Full Cooling System kits, or general cooling topics. Keep specific cooling items like pumps, radiators, etc... in their specific forums. |
![]() |
Thread Tools |
![]() |
#1 |
Cooling Neophyte
Join Date: Dec 2004
Location: Denmark
Posts: 3
|
![]()
Strictly speaking, I guess that 1/2" would end up as 12.5mm approx.
My "problem" is that I have come across some very nice hose, and some very nice fittings, all in 12mm, which I'd like to apply to my radiator and pump as well as my VGA cooler. However, my Swiftech block doesn't really look like the type of component which will allow me to swap the fittings on it. So my question is simply: Using push-in fittings, would you consider 12mm hose in a 1/2" push-in fitting a good enough fit? Or a recipe for disaster? |
![]() |
![]() |
![]() |
#2 | |
Cooling Savant
Join Date: Jan 2004
Location: london, england
Posts: 416
|
![]() Quote:
http://www.swiftnets.com/products/mcw20.asp than they are for 1/2" OD (3/8" ID) so i think they won't fit... |
|
![]() |
![]() |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|