Any maxxxpert miro user here??

yuanlong · 06-27-2003, 07:02 AM

Hi, just like to know is there anyone in the forum using maxxxpert miro watercooling set? Well I like to know isit possible to change the fitting to a 1/2' one since the original one is 3/8'...

and for those who don't know how the wb looks like it as the picture below

bigben2k · 07-03-2003, 03:15 PM

How's the fitting connected to the block?

pakman · 07-06-2003, 12:23 AM

yes you can change the fittings. I didn't have the miro but another Korean made waterblock which was similiar in design and had the same quick connect elbows. Just find some 1/4" thread barbs (Metric thread NOT NPT - which shouldn't be a problem fro you in Malaysia). note the original fittings are for 3/8"OD tubing(outer perimeter).

06-27-2003, 07:02 AM	#1
yuanlong Cooling Neophyte Join Date: May 2003 Location: Malaysia, KL Posts: 39	Any maxxxpert miro user here?? Hi, just like to know is there anyone in the forum using maxxxpert miro watercooling set? Well I like to know isit possible to change the fitting to a 1/2' one since the original one is 3/8'... and for those who don't know how the wb looks like it as the picture below

07-03-2003, 03:15 PM	#2
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	How's the fitting connected to the block? __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101

07-06-2003, 12:23 AM	#3
pakman Cooling Neophyte Join Date: Jul 2003 Location: WA State Posts: 76	yes you can change the fittings. I didn't have the miro but another Korean made waterblock which was similiar in design and had the same quick connect elbows. Just find some 1/4" thread barbs (Metric thread NOT NPT - which shouldn't be a problem fro you in Malaysia). note the original fittings are for 3/8"OD tubing(outer perimeter).

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)