water

Riscoo · 05-19-2003, 02:55 PM

0.5 fins with 1mm between

satanicoo · 05-19-2003, 03:39 PM

thats an original title...

anyway, it looks reasonable, should have an center inlet for better performance.

how would you machine that? :P

jaydee · 05-19-2003, 08:38 PM

I am a little confused. First this post is in the wrong section. Should be in the water block construction section. Second the title says water?

Anyway, .5mm fins would take a good mill with little excess play. Certainly possible though. The outer sloped wass can be done with a ball endmill. Everything else is pretty much standard square endmills. Won't be easy. If you get the base right and actually get water flowing through all those channels you wil havea decent block even without the middle inlet.

05-19-2003, 03:39 PM	#2
satanicoo Cooling Savant Join Date: Nov 2002 Location: portugal Posts: 635	thats an original title... anyway, it looks reasonable, should have an center inlet for better performance. how would you machine that? :P

05-19-2003, 08:38 PM	#3
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	I am a little confused. First this post is in the wrong section. Should be in the water block construction section. Second the title says water? Anyway, .5mm fins would take a good mill with little excess play. Certainly possible though. The outer sloped wass can be done with a ball endmill. Everything else is pretty much standard square endmills. Won't be easy. If you get the base right and actually get water flowing through all those channels you wil havea decent block even without the middle inlet.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)